went to go put the new globes in the headlight today an the black plastic cover over them wen you open the bonnet to get to the f***ers wont come off, the screws jus keep on screwin an never come out, i didnt want to jus yank em out incase i break anything . anyone no wat to do???

Try using the screwdriver very lightly to unscrew them. Once the screw is out, either pull the rivet out, or leave it in and when they are all out, pull the plastic off and they will come out.

They are commonly called scrivets. When you get them out, you will understand why.

I thought you get to the headlights from inside the engine bay. You don't need to take that plastic bit off if we are talking about the same bit. It may be different on the V8, or on non-XR models, but I only have experience with my XR8.

it looked to hard from the engine bay, this jus looked right lol i dont no ill go give it a shot,
cheers man

There should just be some rubber grommit type things you pull out, then unclip the headlight (wire clip), pull out the globe, and do reverse of instructions to put back in.

Shouldn't this be in The Garage some where (the Exterior or the Electronics section)???

put the in last week you were right kilma, you change em from the engine bay, next time ill have a mans look lol
cheers guys

Cool. Good to hear I was of some assistance to someone.