Ok I'm selling my cleveland stuff. No offers and no splitting it up.
CHI 3V 185 heads
CHI 3V 185 intake( brand new)
Platinum shaft rockers
Jet Hyd. roller pushrods
Ford Motorsport rocker covers
Comp roller valve springs
Comp retainers and locks
REV 2.08 & 1.65
Comp Hyd roller lifters(factory style)
Dog bones and spider for roller conversion
.040 over late XE block
351 Crank
Bronze bushed, beam polished, shotpeened ARP bolted 302C rods
NASCAR 12point head bolts
ARP main studs
Edelbrock Victor water pump
Cloyes timing set
Romac balancer
Pioneer SFI flexplate
All done about 10k except the intake which is brand new and comes with special reuseable intake gaskets.

$5000.

Also have cleveland EFI intake, rails and TFI dizzy with steel gear for roller cam $1500.

BTW it also comes with another complete std bore cleveland engine.

If only i had a ford to put it in.

Great value guys, the heads are half of the price tag alone, good luck with the sale.

What's that EF of yours....Chopped Liver?!
An S-trim blown Cleveland sounds like just the shot to me!

Ok $4500 for the bits and $1200 for the EFI stuff.

What sort of HP Pete? (roughly)

Would that setup handle LPG?


Thx
D

Depends on the cam and how you build it. Heads and intake have over 600hp potential NA.
LPG will work.

Put it on AFF yet?

Big clevo following there, you should see it go quicker.

Awesome! I'm off to tap the old bloke on the shoulder.

You couldn't pay me enough money to go on that shit forum or the tickford club one either!

Hehe fair enough...

good luck with the sale, im looking at excuses to get another car to chuck it into but the wallet says no.

You could always put it in your panelvan